Which inhalers need priming

Step 2. Hold the inhaler with the mouthpiece down and shake it well. See Figure E. Step 3. Breathe out through your mouth and push as much air from your lungs as you can. See Figure F. Step 4. Put the mouthpiece in your mouth and close your lips around it. Push the top of the metal canister firmly all the way down while you breathe in deeply and slowly through your mouth.

See Figure G. Step 5. After the spray comes out, take your finger off the metal canister. After you have breathed in all the way, take the inhaler out of your mouth and close your mouth.

Step 6. Hold your breath for about 10 seconds, or for as long as is comfortable. Breathe out slowly as long as you can. For example: Your inhaler canister has puffs in it, you are told to take 8 puffs total every day. For quick-relief medicine, take as needed and count each puff. To keep track of this, use a check off sheet View a printer-friendly version of this page. Asthma Basics All About Asthma. Is Your Asthma Under Control?

Work with Your Health Care Provider. Indoor Air Quality. Indoor Asthma Triggers. Outdoor Air Quality. Building Healthy Homes. Using Inhalers for Asthma at School. Asthma Resources Asthma Resources. Assistance Programs. MI Asthma Surveillance. Alternative Treatments. Guidelines for the Diagnosis and Treatment of Asthma. SYMBICORT budesonide and formoterol fumarate dihydrate should be primed before using for the first time by releasing two test sprays into the air away from the face, shaking well for 5 seconds before each spray.

In cases where the inhaler has not been used for more than 7 days or when it has been dropped, prime the inhaler again by shaking well for 5 seconds before each spray and releasing two test sprays into the air away from the face. Your Symbicort inhaler is now primed and ready for use.

To prime, hold the inhaler upright, with the mouthpiece facing away from you. Shake the inhaler gently, then press the canister firmly and quickly.

Repeat this procedure again so a total of 2 puffs are released. Your Azmacort Inhalation Aerosol is now ready for use. Re-priming is only necessary when your inhaler has not been used for more than 3 days. To re-prime, shake the inhaler and release one puff. Repeat this procedure again so a total of two puffs are released. Articles FAQs Sitemap. Disclaimer: This site is presented for information only and is not intended as a substitute for professional medical advice.

All Rights Reserved. Step 1: Remove your ProAir HFA device from its package Step 2: Remove the protective dust cap from the mouthpiece Step 3: Shake the inhaler well, and spray it into the air away from your face Step 4: Shake and spray the inhaler like this 2 more times to finish priming it. Categories: Respiratory Therapy A properly cared for inhaler results in more consistent and effective treatment for children with asthma.

Priming releasing one or more sprays into the air ensures your child gets an accurate dose of medication. Regular cleaning is also important to keep inhalers working properly, since residue can accumulate around the exit hole, impeding or even blocking the spray completely. Before using a new inhaler, shake it really well, three to four times. This mixes the ingredients in the canister so each dose contains the right blend of medication and propellant.

Medications may have separated from the other ingredients in the canister and the metering chamber. This will help make sure your dose contains the labeled amount of medication.